Nokia 5110 LCD Display Module Ð Red

4-board LED, backlight, light uniformity
PCB Size: 45 (mm) x 45 (mm)
The corners were positioning holes, along with two rows of the upper and lower connection port
Material: Metal

Wiring:

VCC Ð power input ( 3.3v )
GND Ð Ground
SCE Ð Chip Select
RST Ð Reset
D C Ð data / instruction selection
DN Ð Serial Data Line
CLK Ð Serial Clock Line
LED Ð backlit console

Pin Configuration:

• The module typically features 8 signal lines:Ê
• 1. RST:ÊReset (Active Low).
• 2. CE / SCE:ÊChip Enable (Active Low).
• 3. DC / DC:ÊData/Instruction Selection.
• 4. DIN / DN:ÊSerial Data Line (MOSI).
• 5. CLK:ÊSerial Clock Line.
• 6. VCC:ÊPower Input (3.3V or 5VÐ7V depending on revision).
• 7. BL / LIGHT / LED:ÊBacklight Control (typically linked to GND).
• 8. GND:ÊGround.

Features:

• Resolution: 84_48 monochrome pixels, capable of displaying bitmap graphics.
• PCD8544 Controller: Low-power CMOS driver that integrates all necessary functions on a single chip, including bias voltage generation.
• Backlight: Equipped with a built-in backlight (commonly Blue or White depending on specific variant) for visibility in low-light environments.
• Interface: Uses a serial SPI interface, minimizing required signal lines to roughly 5 to 8 pins including power.
• Low Power: Operating current is typically lower than 200µA in normal conditions, with an integrated power-down mode.
• Speed: Supports transfer rates up to 4Mbps, allowing full-speed display data writing without wait times.

Package Includes:

• 1 x Nokia 5110 LCD Display Module (Red PCB)